In the model that I used for many years, a hole of a wood screw of stock grows big, and there is price that a wood screw did not work for.
In addition, I think extremely partly, but there is the thing which was out of a position of a bat plate with a new article.
It is the method how I dealt with for this situation.
Because a grain of wood and a color do not match, I cannot recommend it to an appearance part.

	It is a stock part of M31-RS2. When I disintegrated, a hole of a screw grew big I removed a screw many times, and to do it, and a wooden screw did not suffer.

When I connect wood, this part uses it. In addition, I use it to put a shelf board. I had thickness of two kinds of 6mm and 8mm. I used a thing of 8mm this time.

At first I disintegrate and make it a state only for stock. I enlarge a screw hole with drills. A hole opens out more slightly than a part coming in small at this time. This time buried wood of 8mm, but opened a hole to around 7mm when a cut ditch buried it in circumference because I lost it. I attach glue to the hole which I enlarged and hammer in wood with a hammer. Because wood to bury was softer than stock materials, there was not the problem. It is almost an edge of a stock part and might can break stock if firm materials to bury. Please hammer it in with care. I leave around 1mm and saw it and drop an unnecessary part. Please be careful not to damage stock circumference. Take off what's unnecessary with a rasp and even it out. I put bat plates together and open a lower hole, and it is completion if it tightens a wooden screw. Please confirm a course of a screw then. A screw may not enter horizontally.